R2511-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V5)

16
Ste
p
Command Remarks
5. Configure the PVID of the
trunk ports.
port trunk pvid vlan vlan-id
Optional.
By default, the PVID is VLAN 1.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to configure
the trunk port to allow packets from the PVID to pass through.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view. Before assigning
a hybrid port to a VLAN, create the VLAN first.
Only MSR93X, MSR30, MSR50, and MSR1000 routers support Layer 2 aggregate interfaces.
To assign a hybrid port to one or multiple VLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• The configuration made in Layer 2
Ethernet interface view applies only
to the port.
• The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
3. Configure the link type of
the ports as hybrid.
port link-type hybrid By default, all ports are access ports.
4. Assign the hybrid ports to
the specified VLANs.
port hybrid vlan vlan-list
{ tagged | untagged }
By default, a hybrid port allows only
packets of VLAN 1 to pass through
untagged.
5. Configure the PVID of the
hybrid ports.
port hybrid pvid vlan vlan-id
Optional.
By default, the PVID is VLAN 1.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
After you configure the PVID for a hybrid port, you must use the port hybrid vlan command to configure
the hybrid port to allow packets from the PVID to pass through.