R2511-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V5)

[RouterA] interface bridge-aggregation 1

[RouterA-Bridge-Aggregation1] port link-type trunk

[RouterA-Bridge-Aggregation1] port trunk permit vlan 10 20

Please wait... Done.

Configuring Ethernet1/1... Done.

Configuring Ethernet1/2... Done.

Configuring Ethernet1/3... Done.

[RouterA-Bridge-Aggregation1] quit

2. Configure Router B in the same way Router A is configured.

Verifying the configuration

# Display summary information about all aggregation groups on Router A.

[RouterA] display link-aggregation summary

Aggregation Interface Type:

BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation

Aggregation Mode: S -- Static, D -- Dynamic

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Actor System ID: 0x8000, 000f-e2ff-0001

AGG AGG Partner ID Select Unselect Share

Interface Mode Ports Ports Type

-------------------------------------------------------------------------------

BAGG1 S none 3 0 NonS

The output shows that link aggregation group 1 is a Layer 2 static aggregation group and contains three

Selected ports.

Layer 2 dynamic aggregation configuration example

Network requirements

As shown in Figure 28, configure a Layer 2 dynamic aggregation group on both Router A and Router B.

Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and

VLAN 20 at one end to communicate with VLAN 20 at the other end.

Figure 28 Network diagram