R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

91
Default command level
2: System level
Parameters
indicator: Specifies one of the progress indicators in Table 17.
Table 17 Progress indicator values
Value Descri
p
tion
1 Call is not end-to-end ISDN; further call progress information may be available in-band.
2 Destination address is non-ISDN.
3 Origination address is non-ISDN.
4 Call has returned to the ISDN.
5 Interworking has occurred and has resulted in a telecommunication service change.
8 In-band information or an appropriate pattern is now available.
Examples
# Configure the progress indicator value as 8 for the ISDN signaling messages sent by interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn progress-indicator 8
isdn protocol-mode
Use isdn protocol-mode to set the protocol mode for an ISDN interface.
Use undo isdn protocol-mode to restore the default protocol mode.
Syntax
isdn protocol-mode mode
undo isdn protocol-mode
Default
An ISDN interface operates in user side mode.
Views
Interface view
Default command level
2: System level
Parameters
mode: ISDN protocol mode to be set, which can be network (for network side mode) and user (for user
side mode).
Examples
# Set the protocol mode to network side mode for BRI 2/0 interface (assuming that the interface is a BSV
interface).
<Sysname> system-view
[Sysname] interface bri 2/0