R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

100
negotiation. The system can make the L3 initialization to place calls correctly only after SPID information
is configured for the B2 channel on the BRI interface.
In addition, when the router works with an ISDN NI compliant switch (the DMS100 for example) in North
America, you must use this command to configure a unique SPID and LDN for each B channel to ensure
a successful MP channel call. Otherwise, only one B channel can be brought up. Additionally, both SPID
and LDN are provided by your service provider and the configuration of LDN invalidates the
configuration of the ISDN calling command.
This command applies only on BRI interfaces running the NI protocol.
Examples
# Assign the SPID 012345 and the LDN 54321 to the B2 channel on interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn spid2 012345 54321
isdn statistics
Use isdn statistics to collect statistics about messages sent and received on an ISDN interface.
Use isdn statistics clear to clear the statistics.
Use isdn statistics continue to continue statistics collection.
Use isdn statistics display to display message statistics.
Use isdn statistics display flow to display the statistics in the form of flow.
Use isdn statistics start in ISDN interface view to start collecting incoming and outgoing message
statistics on an ISDN interface.
Use isdn statistics stop to stop collecting statistics.
Syntax
isdn statistics { clear | continue | display [ flow ] | start | stop }
Default
The system does not collect message statistics for an ISDN interface.
Views
ISDN interface view
Default command level
2: System level
Parameters
clear: Clears statistics. If this keyword is specified, the system stops collecting statistics.
continue: Continues to collect statistics.
display: Displays the statistics.
display flow: Displays the statistics about message flows.
start: Starts collecting statistics.
stop: Stops collecting statistics.