R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

102
<Sysname> system-view
[Sysname] interface bri 2/0
[Router-Bri2/0] isdn two-tei
isdn message-conversion progress-to-alerting enable
Use isdn message-conversion progress-to-alerting enable to configure the ISDN interface to convert
received Progress messages into Alerting messages.
Use undo isdn message-conversion progress-to-alerting enable to disable the function on the ISDN
interface.
Syntax
isdn message-conversion progress-to-alerting enable
undo isdn message-conversion progress-to-alerting enable
Default
The Progress-to-Alerting conversion function is enabled.
Views
ISDN interface view
Default command level
2: System level
Usage guidelines
This command takes effect on only messages received on an ISDN interface.
Examples
# Configure the PRI interface Serial2/0:15 to convert received Progress messages into Alerting
messages.
<Sysname> system-view
[Sysname] interface serial 2/0:15
[Sysname-Serial2/0:15] isdn message-conversion progress-to-alerting enable
permanent-active
Use permanent-active to specify an ISDN BRI interface to be in the permanent active state at the physical
layer.
Use undo permanent-active to cancel the configuration.
Syntax
permanent-active
undo permanent-active
Default
BSV interfaces operating on the network side are not in the permanent active state at the physical layer.
Views
ISDN BRI interface view