R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

105
Frame relay configuration commands
Basic frame relay configuration commands
annexg
Use annexg to configure the operating mode (Annex G DCE or Annex DTE) for a PVC.
Use undo annexg to remove the configuration.
Syntax
annexg { dce | dte }
undo annexg { dce | dte }
Default
A DLCI interface does operate in any Annex G mode.
Views
DLCI interface view
Default command level
2: System level
Parameters
dce: Sets the PVC to Annex G DCE mode.
dte: Sets the PVC to Annex G DTE mode.
Usage guidelines
ANSI T1.617 Annex G defines the way to transmit X.25 packets over FR virtual circuits. Similar to a
regular X.25 interface, an Annex G interface transmits X.25 PVC and X.25 SVC packets, and can
operate as an X.25 switching interface.
You can set LAPB- and X.25 parameters for a virtual circuit by using an X.25 template.
Examples
# Set PVC 100 on interface Serial 2/0 to operate in Annex G DTE mode.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fr dlci 100
[Sysname-fr-dlci-Serial2/0-100] annexg dte
display fr dlci-switch
Use display fr dlci-switch to display the frame relay (FR) switching configuration.
Syntax
display fr dlci-switch [ interface interface-type interface-number ] [ | { begin | exclude | include }
regular-expression ]