R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

155
Field Description
vlink
Value for the route that corresponds to the mapping. If the
value is zero, the route is invalid. If the value is nonzero, the
route is valid. This value is used to find the corresponding
mapping, and the DLCI.
broadcast Broadcasting packets is allowed.
Related commands
• fr map ip
• fr inarp
fr map ipv6
Use fr map ipv6 to add an IPv6 static address mapping.
Use undo fr map ipv6 to delete an IPv6 static address mapping.
Syntax
fr map ipv6 { ipv6-address | default } dlci-number [ broadcast ] [ compression frf9 ]
undo fr map ipv6 { ipv6-address | default } dlci-number
Default
IPv6 static address mappings are not configured.
Views
Interface view
Default command level
2: System level
Parameters
ipv6-address: Specifies the IPv6 address of the peer.
default: Creates a default address mapping.
dlci-number: Specifies the local DLCI number in the range of 16 to 1007.
broadcast: Enables broadcasting packets.
compression: Enables FR compression.
frf9: Enables FRF.9 compression.
Usage guidelines
IPv6 address mappings can be configured manually, or automatically through inverse neighbor
discovery (IND).
If there are few peers or a default route exists, you can use this command to manually add address
mappings. If there are many peers, you can use IND to automatically create address mappings.
Examples
# Configure a static IPv6 address mapping that includes the local DLCI 100 and the peer router's IPv6
address 10::2/64 on Serial2/0.
<Sysname> system-view