R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

164
dialer disconnect
Use dialer disconnect to clear the dialup link on an interface or all dialup links if no interface is specified.
Syntax
dialer disconnect [ interface interface-type interface-number ]
Views
Any view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Disconnects the dialup link on an interface specified by its
type and number.
Examples
# Clear the dialup link on interface Dialer 0.
<Sysname> dialer disconnect interface dialer0
dialer enable-circular
Use dialer enable-circular to enable C-DCC.
Use undo dialer enable-circular to disable C-DCC.
Syntax
dialer enable-circular
undo dialer enable-circular
Default
C-DCC is not enabled on an interface.
Views
Dialup interface (physical or dialer interface) view
Default command level
2: System level
Usage guidelines
You must enable C-DCC before you can use it.
To use RS-DCC on a dialer interface, you must configure the dialer user command and the dialer bundle
command on the dialer interface, and assign physical interfaces to the dialer bundle with the dialer
bundle-member command.
After you disable C-DCC, the system clears all configurations on dialup interfaces. To recover the dialer
interfaces, you must re-enable them by using the shutdown command and then the undo shutdown
command. If you use the dialer enable-circular command or its undo form on a non-dialup interface, do
the same on the interface to recover it.
Examples
# Enable C-DCC on interface Serial 2/0.