R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

166
Default
No ISDN B channel is configured for leased line connection.
Views
Dialup interface (physical interface) view
Default command level
2: System level
Parameters
number: Number of the ISDN B channel for leased line connection. The value range is 0 to 1 for a BRI
interface, 0 to 30 (with 15 excluded for the control channel) for a CE1/PRI interface, and 0 to 23 (with
23 excluded for the control channel) for a CT1/PRI interface.
Usage guidelines
You can use any ISDN B channel for leased line connection. However, an ISDN interface with a B
channel configured for leased line connection cannot be used for dialing. Leased line connection is
mutually exclusive with dialing on the same ISDN interface.
On ISDN BRI interfaces, you can also configure ISDN BRI 128 kbps leased lines. For more information,
see the dialer isdn-leased command in Layer 2—WAN Command Reference.
Examples
# Configure the first B channel on interface BRI 2/0 as a leased line.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] dialer isdn-leased 0
dialer number
Use dialer number to configure a dial number for placing calls to a single remote end.
Use undo dialer number to remove the configured dial number.
Syntax
dialer number dial-number
undo dialer number
Default
No dial number is configured for calling the remote end.
Views
Dialup interface (physical or dialer interface) view
Default command level
2: System level
Parameters
dial-number: Dial string for calling a remote end, a string of 1 to 30 characters.
Usage guidelines
You must configure this command when the dialer or physical interface is the calling party.