R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

178
For DCC to send packets correctly, you must configure a dial ACL and associate it with the concerned
dialup interface (physical or dialer interface) by using the dialer-group command.
If no dial ACL is configured for the dialer access group associated with a dialup interface, DCC will drop
received packets on the interface as uninteresting ones.
Examples
# Define dialer-rule 1 and apply it to interface Serial 2/0.
<Sysname> system-view
[Sysname] dialer-rule 1 ip permit
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer-group 1
Related commands
dialer-group
display dialer
Use display dialer to display the DCC-related information about an interface. If no interface is specified,
this command displays the DCC-related information about all the interfaces.
Syntax
display dialer [ interface interface-type interface-number ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display the DCC-related information about all the DCC interfaces.
<Sysname> display dialer
Dialer0 - dialer type = Dialer
Dialer Route:
NextHop_address Dialer_Numbers
Dialer number 003
Dialer Timers(Secs):
Auto-dial:300 Compete:20 Enable:5