R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

180
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If you do not specify the dialer keyword, this command displays information about all interfaces on the
device.
If you specify the dialer keyword without the number argument, this command displays information about
all the dialer interfaces.
Examples
# Display detailed information about interface Dialer 1.
<Sysname> display interface dialer 1
Dialer1 current state: UP
Line protocol current state: UP (spoofing)
Description: Dialer1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is Dialer, baudrate: 64000 bps
Output queue : (Urgent queuing : Length) 50
Output queue : (Protocol queuing : Length) 500
Output queue : (FIFO queuing : Length) 75
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
# Display brief information about interface Dialer 1.
<Sysname> display interface dialer 1 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Dia1 UP UP(s) --
# Display brief information about all Dialer interfaces in DOWN state.
<Sysname> display interface dialer brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Dia1 ADM Administratively
Table 34 Command output
Field Descri
p
tion
current state
Physical state of a dialer interface:
• UP—The dialer interface is physically up.
• DOWN (Administratively)—The dialer interface was shut down with the
shutdown command. To re-enable it, you must run the undo shutdown
command on it.