R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

181
Field Descri
p
tion
Line protocol current state Data link layer protocol state of the dialer interface (up/down).
Description Interface description.
The Maximum Transmit Unit MTU of the dialer interface.
Internet protocol processing Network layer protocol state of the dialer interface (enabled/disabled).
Link layer protocol is PPP Current data link layer protocol.
LCP initial LCP is initialized.
Physical is Dialer The physical interface is a dialer interface.
Output queue : (Urgent queuing :
Length)
Statistics on the packets in the urgent output queue.
Output queue : (Protocol
queuing : Length)
Statistics on the packets in the protocol output queue.
Output queue : (FIFO queuing :
Length)
Statistics on the packets in the FIFO output queue.
Last clearing of counters: Never
Time when statistics on the dialer interfaces were last cleared. Never
indicates the statistics were never cleared.
Last 300 seconds input rate Input interface data rate during the latest 300 seconds.
Last 300 seconds output rate Output interface data rate during the latest 300 seconds.
0 packets input, 0 bytes, 0 drops Statistics on the packets reaching the interface.
0 packets output, 0 bytes, 0
drops
Statistics on the packets sent through the interface.
The brief information of
interface(s) under route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively
down; Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
• Stby—The interface is operating as a backup interface. To see the
primary interface, use the display standby state command (High
Availability Command Reference).
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but its link
is an on-demand link or not present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Protocol Protocol connection state of the interface: UP, DOWN, or UP(s).
Main IP Main IP address of the interface.
Description Description of the interface.