R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

185
Use undo standby routing-group to disable the dynamic route backup function.
Syntax
standby routing-group group-number
undo standby routing-group group-number
Default
The dynamic route backup function is disabled.
Views
Interface view
Default command level
2: System level
Parameters
group-number: Dynamic route backup group number in the range of 1 to 255.
Usage guidelines
Before enabling the dynamic route backup function on a dialup interface, make sure DCC is enabled on
the interface.
Examples
# Enable the dynamic route backup function on interface BRI 3/0.
<Sysname> system-view
[Sysname] interface bri 3/0
[Sysname-Bri3/0] standby routing-group 1
standby routing-rule
Use standby routing-rule to create a dynamic route backup group or add a network segment to be
monitored to the group.
Use undo standby routing-rule to remove a dynamic route backup group or remove a network segment
being monitored from the group.
Syntax
standby routing-rule group-number ip ip-address { mask | mask-length }
undo standby routing-rule group-number [ ip ip-address { mask | mask-length } ]
Default
No dynamic route backup group is created.
Views
System view
Default command level
2: System level
Parameters
group-number: Dynamic route backup group number in the range of 1 to 255.
ip ip-address: IP address of the network segment to be monitored.