R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

215
inarp: Enables InARP on the PVC.
minutes: Time interval to send InARP packets in minutes. The value range for this argument is 1 to 600,
and the default is 15 minutes.
broadcast: Enables pseudo-broadcast. If the mapping of a PVC is configured with pseudo-broadcast, the
device sends on the PVC a copy of each broadcast or multicast packet that it sends out of the interface
to which the PVC belongs.
You must configure the broadcast keyword on an ATM PVC where broadcast or multicast packets must be
sent, for example, to allow PIM multicast to create neighbor relationship with the router connected using
the ATM interface.
Usage guidelines
Before configuring InARP, make sure the aal5snap encapsulation is used. InARP is not supported when
using aal5mux or aal5nlpid encapsulations.
Examples
# Create an IPoA mapping on PVC 1/32, specifying the opposite IP address to 61.123.30.169 and
supporting pseudo-broadcast.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc 1/32
[Sysname-atm-pvc-Atm1/0-1/32] map ip 61.123.30.169 broadcast
# Enable InARP on PVC 1/33 and send InARP packets every 10 minutes.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc 1/33
[Sysname-atm-pvc-Atm1/0-1/33] map ip inarp 10
map ppp
Use map ppp to create a PPPoA map on the PVC.
Use undo map ppp to delete the map.
Syntax
map ppp virtual-template vt-number
undo map ppp
Default
No mapping is configured.
Views
PVC view, ATM class view
Default command level
2: System level
Parameters
vt-number: Specifies the number of the VT interface corresponding to a PPPoA mapping.