R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

223
Views
ATM interface view
Default command level
2: System level
Parameters
vpi: Specifies the VPI of the ATM network, in the range of 0 to 255.
output-scr: Specifies the sustainable rate of ATM cell output (in kbps). For more information about the
value range, see Table 46.
Usage guidelines
When applying VP policing, the parameters of PVC are still valid. Only when the parameters of PVC and
VP policing are met, will the packets be transmitted and received. In calculating the traffic, the LLC/SNAP,
MUX and NLPID headers are included, but the ATM cell header is not included.
Examples
# Set the traffic of VP with vpi 1 to 2000 Kbps.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvp limit 1 2000
Related commands
• pvc
• service cbr
• service vbr-nrt
• service vbr-rt
• service ubr
remark atm-clp
Use remark atm-clp to configure the action of setting the CLP bit for ATM cells for the traffic behavior.
Use undo remark atm-clp to cancel the action.
Syntax
remark atm-clp atm-clp-value
undo remark atm-clp
Default
The action of marking the CLP flag bit of ATM cells is not configured.
Views
Traffic behavior view
Default command level
2: System level
Parameters
atm-clp-value: Specifies the value of the CLP bit in an ATM cell. The value of this argument is 0 or 1. When
congestion occurs, ATM cells with CLP 1 are dropped preferentially.