R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

228
Parameters
output-pcr: Specifies the peak cell rate of ATM output (in kbps). For more information about the value
range, see Table 46.
output
-scr: Specifies the sustainable cell rate of ATM output (in kbps). Its value ranges are the same as
those of the output-pcr argument.
output-mbs: Specifies the maximum burst size of ATM cell output, which specifies the maximum cache
size of ATM cell output at the interface in cell number. The value range for this argument is 1 to 512.
When it is used in ATM E3 interface, the value range for this argument is 1 to 512.
Usage guidelines
You can use this command as well as the service ubr, service cbr and service vbr-nrt commands to set
the service type and rate-related parameters of a PVC. A newly configured PVC service type overwrites
the existing one. This command is not applicable to ATM E1 interfaces.
Examples
# Create a PVC named aa with the VPI/VCI value of 1/101.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc aa 1/101
# Specify the service type of the PVC as rt-VBR, setting the peak cell rate of ATM to 100000 kbps, the
sustainable cell rate to 50000 kbps, and the maximum burst size to 320 cells.
[Sysname-atm-pvc-Atm1/0-1/101-aa] service vbr-rt 100000 50000 320
Related commands
• service vbr-nrt
• service ubr
• service cbr
shutdown
Use shutdown to shut down an interface.
Use undo shutdown to bring up an interface.
Syntax
shutdown
undo shutdown
Default
An interface is up.
Views
ATM interface view, Layer 3 VE interface view, Layer 3 VE subinterface view
Default command level
2: System level
Examples
# Shut down interface ATM 5/0.
<Sysname> system-view