R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

235
DLSw configuration commands
code
Use code to configure the encoding format for the synchronous serial interface.
Use undo code to remove the current configuration.
Syntax
code { nrz | nrzi }
undo code
Default
The NRZ encoding scheme is used on the synchronous serial interface.
Views
Synchronous serial interface view
Default command level
2: System level
Parameters
nrz: Sets the digital signal coding format to nonreturn to zero (NRZ).
nrzi: Sets the digital signal coding format to nonreturn to zero inverted (NRZI).
Usage guidelines
Two encoding schemes, NRZI and NRZ, are available for synchronous serial interface. The NRZ
encoding scheme is used for synchronous serial interfaces of routers. However, the serial interfaces of
some SNA devices use NRZI encoding. The encoding scheme of routers should be changed according
to the encoding schemes used on the connected devices.
Examples
# Configure Serial 2/0 to use NRZI encoding.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] code nrzi
display dlsw circuits
Use display dlsw circuits to view the DLSw virtual circuit information. If you specify the IP address of a
remote DLSw peer, this command displays information about the virtual circuits established with the
remote peer.
Syntax
display dlsw circuits [ circuit-id | remote ip-address ] [ verbose ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view