R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

274

Usage guidelines

When an SDLC frame is converted into an LLC2 frame, a SAP address is needed in addition to the MAC

address.

The SAP address used by the SNA protocol is 0x04, 0x08, or 0x0C.

Examples

# Configure the SAP address to be used in SDLC-to-LLC2 frame format conversion on Serial 2/0.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] sdlc sap-map local 08 05

Related commands

sdlc sap-map remote

Use sdlc sap-map remote to configure the SAP address of the remote DLSw device to be used in the LLC2

frames converted from SDLC frames.

Use undo sdlc sap-map remote to restore the system default.

Syntax

sdlc sap-map remote dsap sdlc-addr

undo sdlc sap-map remote dsap sdlc-addr

Default

The SAP address of the remote DLSw device used in SDLC-to-LLC2 frame format conversion is 0x04.

Views

Synchronous serial interface view

Default command level

2: System level

Parameters

dsap: SAP address of the DLSw peer device, in the range of 0x01 to 0xFE.

sdlc-addr: SDLC address in the range of 0x01 to 0xFE.

Usage guidelines

When an SDLC frame is converted to an LLC2 frame, a SAP address is needed in addition to the MAC

address.

The SAP address used by the SNA protocol is 0x04, 0x08, or 0x0C.

Examples

# Configure the SAP address of the remote DLSw device for use in SDLC-to-LLC2 frame format conversion

on Serial 2/0.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] sdlc sap-map remote 0C 05