R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

279
Views
Synchronous serial interface view
Default command level
2: System level
Parameters
sdlc-address: SDLC address of the XID, in the range of 0x01 to 0xFE. This address should be configured
beforehand.
xid-number: XID of the SDLC-enabled device, a 4-byte integer, in the range of 1 to 0xFFFFFFFF. The first
12 bits indicate the network address, and the last 20 bits indicate the node number.
Usage guidelines
An XID identifies a device in an SNA system. When you configure an SDLC connection, pay attention to
the types of the connected SNA devices. Devices in an SNA system include two types: PU2.0 and PU2.1.
An XID has been pre-configured on PU2.1 devices, so they can announce their identity by exchanging
the XID. A PU2.0 device does not come with an XID. This command is required on PU2.0 devices for
specifying an XID.
Examples
# Set the XID of the device with SDLC address 0x05 to 0x2000 on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc xid 05 2000