R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

18
Usage guidelines
Because a slow link takes a long period of time to transmit large packets, the sending and receiving of
keepalives might be delayed so long that one end cannot receive keepalive packets from the peer for a
specific number of keepalive periods and shuts down the link. To prevent this, set the interval for sending
keepalive packets to a relatively longer length of time.
Examples
# Set the interval for sending keepalive packets to 20 seconds on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] timer hold 20
MP configuration commands
MSR93X routers do not support the commands in this section.
bandwidth
Use bandwidth to set the intended bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
VT interface view, MP-group interface view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the intended bandwidth in the range of 1 to 4294967295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used by the network for bandwidth monitoring. It does not affect the actual
bandwidth of the interface.
Examples
# Set the intended bandwidth to 1000 kbps for interface VT 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] bandwidth 1000
# Set the intended bandwidth to 1000 kbps for interface MP-group 3.
<Sysname> system-view
[Sysname] interface mp-group 3
[Sysname-Mp-group3] bandwidth 1000