R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

295
• Specify the exact mode for fragments filtering on the interface.
Your configuration takes effect only on the VA interfaces created after the configuration is performed.
Examples
# Specify the exact fragment match mode for all firewalls on the VA interfaces created based on VT 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] ppp access-control match-fragments exactly
reset l2tp tunnel
Use reset l2tp tunnel to disconnect tunnels and all sessions of the tunnels.
Syntax
reset l2tp tunnel { id tunnel-id | name remote-name }
Views
User view
Default command level
2: System level
Parameters
id tunnel-id: Specifies a tunnel by its local ID.
name remote-name: Specifies tunnels by the tunnel name at the remote end, a case-sensitive string of 1
to 30 characters.
Usage guidelines
The following matrix shows the argument and router compatibility:
Ar
g
ument MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
tunnel-id
Yes.
Value
range: 1
to 256.
Yes.
Value
range: 1
to 256.
Yes.
Value
range: 1 to
256.
Yes.
Value
range: 1
to 256.
Yes.
Value
range: 1
to 512.
Yes.
Value
range: 1 to
1024 for
MPUF and 1
to 4096 for
MPU-G2.
Yes.
Value
range: 1 to
256.
If you specify a tunnel name, all tunnels with the name will be disconnected. If no tunnel with the name
exists, nothing happens.
If you specify a tunnel ID, only the tunnel with the ID is disconnected.
A tunnel disconnected by force can be re-established when a client makes a call.
Examples
# Disconnect all tunnels with the remote name of aaa.
<Sysname> reset l2tp tunnel name aaa
Related commands
display l2tp tunnel