R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

316
Default command level
2: System level
Parameters
dlci: Specifies the local virtual circuit number in the range of 16 to 1007.
broadcast: Specifies to allow bridging of broadcasts over this FR-to-bridging mapping.
Examples
# Create an FR-to-bridging mapping on the virtual circuit by the DLCI of 50 on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dce
[Sysname-Serial2/0] fr dlci 50
[Sysname-Serial2/0] bridge-set 1
[Sysname-Serial2/0] fr map bridge 50 broadcast
Related commands
display fr map-info
interface bridge-template
Use interface bridge-template to create a bridge-template interface for a bridge set.
Use undo interface bridge-template to remove a bridge-template interface.
Syntax
interface bridge-template bridge-set
undo interface bridge-template bridge-set
Views
System view
Default command level
2: System level
Parameters
bridge-set: Specifies the bridge set number, an integer in the range of 1 to 255.
Usage guidelines
A bridge set can have only one bridge-template interface.
Examples
# Create a bridge-template interface for bridge set 1.
<Sysname> system-view
[Sysname] interface bridge-template 1
[Sysname-Bridge-template1]
Related commands
bridge routing-enable