R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

23
Field Descri
p
tion
Last clearing of counters: Never
Last time when statistics on the interface were cleared. Never
indicates that statistics on the interface were never cleared.
Last 300 seconds input rate: 0
bytes/sec 0, 0 bits/sec, packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Average rate of input packets and output packets in the last 300
seconds.
0 packets input, 0 bytes, 0 drops
Total amount of the inbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the inbound packets.
0 packets output, 0 bytes, 0 drops
Total amount of outbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the outbound packets.
The brief information of interface(s)
under route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown command.
• Stby—The interface is operating as a backup interface. To see the
primary interface, use the display standby state command in
High Availability Command Reference.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but
its link is an on-demand link or is not present at all, its protocol
attribute includes the spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut down. To recover
its physical state, use the undo shutdown command.
Protocol Protocol connection state of the interface: UP, DOWN, or UP(s).
Main IP Main IP address of the interface.
Description Description of the interface.
Cause
Cause of a DOWN physical link. If the port has been shut down with
the shutdown command, this field displays Administratively. To
restore the physical state of the interface, use the undo shutdown
command.
display interface virtual-template
Use display interface virtual-template to display information about a VT.
Syntax
display interface virtual-template number [ brief ] [ | { begin | exclude | include } regular-expression ]
display interface [ virtual-template ] [ brief [ down ] ] [ | { begin | exclude | include }
regular-expression ]