R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

354
Views
Interface view
Default command level
2: System level
Parameters
protocol-type: Protocol type. IP is available.
Usage guidelines
During X.25 SVC setup, the called device will check the call user data field of X.25 call request packet.
If it is an unidentifiable one, the called device will deny the setup of the call connection. However, a user
can specify a default upper-layer protocol carried over X.25. When X.25 receives a call with unknown
CUD, the call can be treated based on the default upper-layer protocol specified by a user.
Examples
# Set the default upper-layer protocol over the X.25 interface Serial 2/0 to IP.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 default-protocol ip
x25 flowcontrol
Use x25 flowcontrol to enable flow control negotiation for X.25 switching on the interface.
Use undo x25 flowcontrol to disable flow control negotiation for X.25 switching on the interface.
Syntax
x25 flowcontrol
undo x25 flowcontrol
Default
Flow control negotiation is enabled for X.25 switching on interfaces.
Views
Interface view
Default command level
2: System level
Examples
# Enable flow control negotiation for X.25 switching on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 flowcontrol
x25 hunt-group
Use x25 hunt-group to create or enter an X.25 hunt group.
Use undo x25 hunt-group to delete the specified X.25 hunt group.