R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

356
Usage guidelines
According to X.25, the calling request packet must carry the address. However, on some occasions, the
X.25 calling request does not have to carry the called/calling DTE address in a specific network
environment or as is required by the application. This command enables users to specify whether the call
request packet sent by X.25 in the device carries the called DTE address.
Examples
# Specify the call request packet from the X.25 interface Serial 2/0 not to carry the called DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 ignore called-address
Related commands
• x25 response called-address
• x25 response calling-address
• x25 ignore calling-address
x25 ignore calling-address
Use x25 ignore calling-address to enable it to ignore the X.121 address of the calling DTE when X.25
initiates calls.
Use undo x25 ignore calling-address to disable this function.
Syntax
x25 ignore calling-address
undo x25 ignore calling-address
Default
This function is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
According to X.25, the calling request packet must carry the address. However, on some occasions, the
X.25 calling request does not have to carry the called/calling DTE address in a specific network
environment or as is required by the application. This command enables users to specify whether the call
request packet sent by X.25 in the device carries the calling DTE address.
Examples
# Specify the call request packet from the X.25 interface Serial 2/0 not to carry the calling DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 ignore calling-address
Related commands
• x25 response called-address