R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

366
Default command level
2: System level
Usage guidelines
According to X.25, the call reception packet can optionally carry an address code group, depending on
the specific network requirements. This command enables users to easily specify whether the packet
carries the called DTE address.
Examples
# Specify that the call receiving packet of a call sent from the X.25 interface Serial 2/0 carries the called
DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 response called-address
Related commands
• x25 response calling-address
• x25 ignore called-address
• x25 ignore calling-address
x25 response calling-address
Use x25 response calling-address to enable X.25 to carry the address information of the calling DTE in
call reception packets
Use undo x25 response calling-address to disable the function.
Syntax
x25 response calling-address
undo x25 response calling-address
Default
This function is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
According to X.25, the call reception packet of a call may or may not carry an address code group,
depending on the specific network requirements. This command enables users to easily specify whether
the call reception packet carries the calling DTE address.
Examples
# Specify that the call reception packet of a call sent from the X.25 interface Serial 2/0 carries the calling
DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 response calling-address