R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

372
The output interface of the SVC switching can be an X.25 interface, or FR interface Annex G DLCI. The
link layer of the output interface must be X.25, or FR with the Annex G DLCI configured for output.
Before using this command, you should use the x25 switching command to enable X.25 switching.
Examples
# Configure an SVC to forward the packet to the X.121 address 20112451 through interface Serial 2/0.
<Sysname> system-view
[Sysname-Serial2/0] x25 switch svc 20112451 interface serial 2/0
# Configure an SVC to forward the packet to the address 3 through the Annex G DLCI 100 of interface
Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr dlci 100
[Sysname-Serial2/0] annexg dce
[Sysname-Serial2/0] quit
[Sysname] x25 switch svc 3 interface serial 2/0 dlci 100
# Switch the packets destined to virtual circuit 1189 to interface Serial 2/0, and replace the destination
address 1189 with 2289.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol x25 dce ietf
[Sysname-Serial2/0] quit
[Sysname] x25 switch svc ^11..$ sub-dest ^22..$ interface serial 2/0
x25 switch svc hunt-group
Use x25 switch svc hunt-group to add an X.25 switching SVC whose forwarding address is a hunt group.
Use undo x25 switch svc hunt-group to delete the specified X.25 switching SVC.
Syntax
x25 switch svc x.121-address [ sub-dest destination-address | sub-source source-address ] * hunt-group
hunt-group-name [ xot-source interface-type interface-number ]
undo x25 switch svc x.121-address [ sub-dest destination-address ] [ sub-source source-address ]
[ hunt-group hunt-group-name ] [ xot-source interface-type interface-number ]
Default
No X.25 switching SVC is configured.
Views
System view
Default command level
2: System level
Parameters
x.121-address: Destination X.121 address, a pattern matching string of 1 to 15 characters. For the specific
description of pattern matching, see Table 80 and Table 81. If no w
ildcards are used, the X.121 address
must be exactly matched.