R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

374
Default command level
2: System level
Parameters
x.121-address: Destination address of X.121, a mode matching string with a 1 to 15 characters. For the
specific description of mode matching, see Table 80 and Table 81.
If no wildcard is used, the X.121
address must exactly match.
sub-dest destination-address: X.121 address, a string of 1 to 15 characters. The system replaces the
destination DTE address in the call request packet with the destination-address.
sub-source source-address: X.121 address, a string of 1 to 15 characters. The system replaces the source
DTE address in the call request packet with the source-address.
xot ip-address&<1-6>: Specifies the destination IP address of XOT connection, up to 6 addresses can be
configured.
xot-option: XOT channel parameter option.
Table 82 XOT channel parameter options
O
p
tion Descri
p
tion
timer seconds
Keepalive timer delay of XOT connection, in the range
of 1 to 3600 seconds. The timer sends the keepalive
packet on timeout to detect the connection availability.
retry times
Number of maximum retries of sending keepalive, in
the range of 1 to 3600. If the number exceeds times,
the XOT connection will be disconnected.
source interface-type interface-number
Type and number of the interface that initiates the XOT
connection.
Usage guidelines
After configuring the XOT switching command of X.25 SVC, a user can cross IP network from the local
X.25 network to implement the interconnection with the remote X.25 network. If a user configures the
keepalive attribute, the link detection for XOT will be supported.
Examples
# Configure a XOT route and forward the packet whose destination X.121 address is 1 to the destination
address whose IP address is 10.1.1.1.
<Sysname> system-view
[Sysname] x25 switch svc 1 xot 10.1.1.1
x25 switching
Use x25 switching to enable the X.25 switching function.
Use undo x25 switching to disable this function, which will not affect the established virtual circuit
switching.
Syntax
x25 switching
undo x25 switching