R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

375
Default
X.25 packet switching function is disabled.
Views
System view
Default command level
2: System level
Usage guidelines
X.25 packet switching accepts packets from an X.25 interface and sends them to a certain interface
based on the destination information contained in the packets. The device with this function can be used
as a small-sized packet switch.
Examples
# Enable X.25 switching function.
<Sysname> system-view
[Sysname] x25 switching
x25 timer hold
Use x25 timer hold to set the delay for sending another calling request to a destination to which a
previous request failed to reach.
Use undo x25 timer hold to restore the default.
Syntax
x25 timer hold minutes
undo x25 timer hold
Default
The delay time is 0 second.
Views
Interface view
Default command level
2: System level
Parameters
minutes: Value of delay time in minutes, in the range 0 to 1000.
Usage guidelines
Frequently sending call requests to a wrong destination (which does not exist or is faulty) will deteriorate
the operating efficiency of the device. Using this function can avoid this problem to a certain extent. If the
previous call failed at one destination, the X.25 would not send calls to such a destination again within
the specified time.
If this parameter is set to 0, it is equal to disabling the function. In addition, this function is only effective
on the calls originating from the local and does not take effect when the X.25 operates in the switching
mode.