R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

378
Parameters
seconds: Time of calling request (indication) sending timer, in the range of 1 to 1000 seconds.
Usage guidelines
According to X.25, a timer should be started when the DTE sends a call request (or the DCE sends a call
indication). If no peer acknowledgement is received after the timer timeout, the sending end will take
some measures to guarantee the normal proceeding of the local procedure. This parameter specifies the
time of this timer.
Examples
# Set calling request (indication) sending timer to 100 seconds on the X.25 interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx1 100
Related commands
• x25 timer tx0
• x25 timer tx2
• x25 timer tx3
x25 timer tx2
Use x25 timer tx2 to set the reset request (indication) timer for DTE (or DCE).
Use undo x25 timer tx2 to restore the default.
Syntax
x25 timer tx2 seconds
undo x25 timer tx2
Default
The timer on a DTE is 180 seconds, and that on a DCE is 60 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Reset request (indication) timer in the range of 1 to 1000 seconds.
Usage guidelines
According to X.25, a timer should be started when a DTE sends a reset request (or a DCE sends a reset
indication). If no peer acknowledgement is received after the timer timeout, the sending end will take
some measures to guarantee the normal proceeding of the local procedure.
Examples
# Set the reset timer to 120 seconds on the X.25 interface Serial 1/0.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] x25 timer tx2 120