R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

379
Related commands
• x25 timer tx0
• x25 timer tx1
• x25 timer tx3
x25 timer tx3
Use x25 timer tx3 to set the clear request (indication) sending timer for DTE (or DCE).
Use undo x25 timer tx3 to restore the default.
Syntax
x25 timer tx3 seconds
undo x25 timer tx3
Default
The clear timer on a DTE is 180 seconds, and that on a DCE is 60 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Time of the clear request (indication) sending timer, in the range of 1 to 1000 seconds.
Usage guidelines
According to X.25, a timer should be started when a DTE sends a clear request (or a DCE sends a clear
indication). If no peer acknowledgement is received after the timer timeout, the sending end will take
some measures to guarantee the normal proceeding of the local procedure.
Examples
# Set the clear timer to 100 seconds on the X.25 interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx3 100
Related commands
• x25 timer tx0
• x25 timer tx1
• x25 timer tx2
x25 vc-per-map
Use x25 vc-per-map to set the maximum number of VCs for connections with the same destination
device.
Use undo x25 vc-per-map to restore the default.
Syntax
x25 vc-per-map count