R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

33
Views
Virtual template interface view, dialer interface view, MP-group interface view
Default command level
2: System level
Parameters
max-bind-num: Maximum number of links allowed in an MP bundle, in the range of 1 to 128.
Usage guidelines
Use the default setting in normal cases. Inappropriate use of this command can cause PPP performance
degradation. Make sure you understand the impact of this command on your network before you use it.
If the maximum number of links allowed in an MP bundle configured is less than the actual link number
of an MP bundle, you will fail in MP bundling. Therefore, make sure that the maximum link number
configured is larger than the actual one.
After you change the maximum number of bundled links for an MP bundle, you must shut down and then
bring up all the physical interfaces bound to the MP bundle for the modification to take effect.
Examples
# Set the maximum number of links allowed in an MP bundle to 12.
<Sysname> system-view
[Sysname] interface virtual-template 0
[Sysname-Virtual-Template0] ppp mp max-bind 12
Related commands
ppp mp
ppp mp min-bind
Use ppp mp min-bind to set the minimum number of links required in an MP bundle.
Use undo ppp mp min-bind to restore the default.
Syntax
ppp mp min-bind min-bind-num
undo ppp mp min-bind
Default
The minimum number of PPP links required in an MP bundle is 0, which means that MP dial-up relies on
traffic detection.
Views
Dialer interface view
Default command level
2: System level
Parameters
min-bind-num: Minimum number of links required in an MP bundle, in the range of 0 to 128.