R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

36
Default
The long sequence number header format is used.
Views
Interface view
Default command level
2: System level
Usage guidelines
This command applies to the incoming direction only. To enable the local end to transmit packets with
short sequence numbers, configure the remote end to receive packets with short sequence numbers.
The sequence number format (long or short) of an MP bundle depends on the configuration of the first
channel joining the MP bundle.
To negotiate the use of short sequence numbers on a dialer MP bundle, configure the command on the
dialer interfaces and the ISDN D channels; to do that on a common MP bundle, use the command on all
its channels. The command will cause PPP re-negotiation.
Examples
# Configure the short sequence number header format of MP in the incoming direction of interface Serial
2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ppp mp mp-group 0
ppp mp soft-binding
Syntax
ppp mp soft-binding
undo ppp mp soft-binding
Default
MP binding is supported in hardware.
Views
CPOS interface view
Default command level
2: System level
Parameters
None
Description
Use ppp mp soft-binding to configure software support for MP binding.
Use undo ppp mp soft-binding to restore the default.
Software support for MP binding can only be configured on CPOS interfaces.
For software support to take effect, you must configure the interface to operate in MP mode after
configuring software support.