R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

59
ID: 1 Interface: Eth1/1
InPackets: 19 OutPackets: 19
InBytes: 816 OutBytes: 816
InDrops: 0 OutDrops: 0
ID: 2 Interface: Eth1/1
InPackets: 18 OutPackets: 18
InBytes: 730 OutBytes: 730
InDrops: 0 OutDrops: 0
Table 8 Command output
Field Descri
p
tion
ID PPPoE session ID.
Interface Ethernet interface corresponding to a PPPoE session.
InPackets Number of packets received.
InBytes Size of received packets (in bytes).
InDrops Number of received packets discarded.
OutPackets Number of packets sent.
OutBytes Size of sent packets (in bytes).
OutDrops Number of sent packets discarded.
pppoe-client
Use pppoe-client to establish a PPPoE session and specify the dialer bundle corresponding to the session.
Use undo pppoe-client to remove a PPPoE session.
Syntax
pppoe-client dial-bundle-number number [ no-hostuniq ] [ idle-timeout seconds [ queue-length
packets ] ]
undo pppoe-client dial-bundle-number number
Default
No PPPoE session is established.
Views
Ethernet interface view, virtual Ethernet interface view, VLAN interface view
Default command level
2: System level
Parameters
dial-bundle-number number: Specifies the dialer bundle number corresponding to a PPPoE session, in
the range of 1 to 255. A dialer bundle number uniquely identifies a PPPoE session, it can also be used
as a PPPoE session ID.
no-hostuniq: Configures the client to not carry the Host-Uniq field. By default, the Host-Uniq field is
carried.