R2511-HP MSR Router Series Layer 2 - WAN Command Reference(V5)

61
Default
The PPPoE session negotiation timer is 10 seconds.
Views
System view
Default command level
2: System level
Parameters
seconds: Specifies a value for the PPPoE session negotiation timer, in the range of 10 to 600 seconds.
Usage guidelines
To establish a PPPoE session, the PPPoE client sends negotiation requests to the PPPoE server. The PPPoE
client deletes the peer-to-peer relationship previously established with the server if PPP negotiation is not
completed before the timer expires.
Examples
# Set the PPPoE session negotiation timer to 15 seconds.
<Sysname> sys
[Sysname] pppoe-client timer negotiation 15
reset pppoe-client
Use reset pppoe-client to reset a PPPoE session corresponding to a dialer bundle for the PPPoE session to
be initiated again.
Syntax
reset pppoe-client { all | dial-bundle-number number }
Views
User view
Default command level
2: System level
Parameters
all: Clears all the PPPoE sessions.
dial-bundle-number number: Specifies a dialer bundle by its number in the range of 1 to 255.
Usage guidelines
A PPPoE session in permanent mode and terminated by this command will be established again in 16
seconds. A PPPoE session in packet-triggered mode and terminated by this command will be established
again only when there is a need for data transmission.
The difference between the reset pppoe-client command and the undo pppoe-client command lies in:
the former only temporarily terminates a PPPoE session, but the latter permanently removes a PPPoE
session.
Examples
# Reset all the PPPoE sessions.
<Sysname> reset pppoe-client all