R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

107
Views
OSPF view
Default command level
2: System level
Parameters
interval: Specifies the LSA arrival interval in milliseconds, in the range of 0 to 60000.
Usage guidelines
If an LSA that has the same LSA type, LS ID, originating router ID with the previous LSA is received within
the interval, the LSA is discarded. This feature helps protect routers and bandwidth from being
over-consumed due to frequent network changes.
HP recommends setting the interval with the lsa-arrival-interval command to be smaller than or equal to
the initial interval set with the lsa-generation-interval command.
Examples
# Set the LSA arrival interval to 200 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-arrival-interval 200
Related commands
lsa-generation-interval
lsa-generation-interval
Use lsa-generation-interval to configure the OSPF LSA generation interval.
Use undo lsa-generation-interval to restore the default.
Syntax
lsa-generation-interval maximum-interval [ initial-interval [ incremental-interval ] ]
undo lsa-generation-interval
Default
The maximum interval is 5 seconds, the minimum interval is 0 milliseconds, and the incremental interval
is 5000 milliseconds.
Views
OSPF view
Default command level
2: System level
Parameters
maximum-interval: Specifies the maximum LSA generation interval in seconds, in the range of 1 to 60.
The default is 5.
initial-interval: Specifies the minimum LSA generation interval in milliseconds, in the range of 10 to
60000. The default is 0.