R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

121
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] ospf timer retransmit 8
ospf trans-delay
Use ospf trans-delay to set the LSA transmission delay on an interface.
Use undo ospf trans-delay to restore the default.
Syntax
ospf trans-delay seconds
undo ospf trans-delay
Default
The LSA transmission delay is 1 second.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Specifies the LSA transmission delay in seconds, in the range of 1 to 3600.
Usage guidelines
Each LSA in the LSDB has an age that is incremented by 1 every second, but the age does not change
during transmission. It is necessary to add a transmission delay into its age time, which is important for
low speed networks.
Examples
# Set the LSA transmission delay to 3 seconds on an interface.
<Sysname> system-view
[Sysname] interface Ethernet 1/1
[Sysname-Ethernet1/1] ospf trans-delay 3
peer
Use peer to specify a neighbor, and the DR priority of the neighbor.
Use undo peer to remove the configuration.
Syntax
peer ip-address [ cost value | dr-priority dr-priority ]
undo peer ip-address
Views
OSPF view
Default command level
2: System level