R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

125
Use undo rfc1583 compatible to disable the function.
Syntax
rfc1583 compatible
undo rfc1583 compatible
Default
Compatibility with RFC 1583 is enabled.
Views
OSPF view
Default command level
2: System level
Usage guidelines
RFC 1583 and RFC 2328 use different rules for selecting the best route among multiple AS external routes
destined for the same network. Using this command can make them compatible. If RFC 2328 is
compatible with RFC 1583, the intra-area route in the backbone area is preferred, if not, the intra-area
route in the non-backbone area is preferred to reduce the burden of the backbone area.
Examples
# Disable compatibility with RFC 1583.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] undo rfc1583 compatible
router id
Use router id to configure a global router ID.
Use undo router id to remove the global router ID.
Syntax
router id router-id
undo router id
Default
No global router ID is configured.
Views
System view
Default command level
2: System level
Parameters
router-id: Specifies the router ID, in the form of a dotted decimal IPv4 address.
Usage guidelines
Some routing protocols use a router ID to identify a device. You can configure a global router ID, which
is used by routing protocols that have no router ID configured.