R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

1
Basic IP routing commands
bandwidth-based-sharing
Use bandwidth-based-sharing to enable bandwidth-based load sharing.
Use undo bandwidth-based-sharing to disable bandwidth-based load sharing.
Syntax
display ipv6 routing-table [ vpn-instance vpn-instance-name ] acl acl6-number [ verbose ] [ | { begin |
exclude | include } regular-expression ]
Default
Bandwidth-based load sharing is disabled.
Views
System view
Default command level
2: System level
Usage guidelines
If multiple outbound interfaces/next hops to a destination are found during packet forwarding:
• When bandwidth-based load sharing is disabled, all the interfaces are used for packet forwarding
in turn.
• When bandwidth-based load sharing is enabled, the device calculates the packet forwarding
proportion for each interface based on the bandwidths of all the interfaces, and then determines
through which interfaces to forward subsequent packets based on both the interfaces' packet
forwarding proportions and the number of packets each interface has forwarded.
Examples
# Enable bandwidth-based load sharing.
<Sysname> system-view
[Sysname] bandwidth-based-sharing
display ip routing-table
Use display ip routing-table to display brief information about active routes in the routing table.
Use display ip routing-table verbose to display detailed information about all routes in the routing table.
Syntax
display ip routing-table [ vpn-instance vpn-instance-name ] [ verbose ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view
Default command level
1: Monitor level