R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

144
Field Descri
p
tion
MTU Interface MTU.
Type Interface link adjacency type.
DIS Whether the interface is elected as the DIS or not.
SNPA Address Subnet access point address.
IP Address Primary IP address.
Secondary IP Address(es) Secondary IP addresses.
IPV6 Link Local Address IPv6 link local address.
IPV6 Global Address(es) IPv6 global address.
Csnp Timer Value Interval for sending CSNP packets.
Hello Timer Value Interval for sending Hello packets.
Hello Multiplier Value Number of invalid Hello packets.
Lsp Timer Value Minimum interval for sending LSP packets.
Lsp Transmit-Throttle Count Number of LSP packets sent each time.
Cost Cost of the interface.
Priority DIS priority.
Retransmit Timer Value LSP retransmission interval over the point-to-point link.
BFD Whether BFD is enabled on the interface.
MPLS TE Status Whether MPLS TE is enabled on the interface.
INTF L1 TE Status Whether level-1 MPLS TE is enabled on the interface.
INTF L2 TE Status Whether level-2 MPLS TE is enabled on the interface.
TE Cost MPLS TE cost configured on the interface.
TE Admin Group TE link administration group.
TE Max Bandwidth TE link maximum bandwidth.
TE Max Res Bandwidth TE link maximum reserved bandwidth.
Tunnel L1 State IS-IS TE tunnel level-1 state.
Tunnel L2 State IS-IS TE tunnel level-2 state.
Tunnel Type Tunnel type.
Tunnel Metric IGP metric of the TE tunnel.
Destination Router ID Destination address of TE tunnel interface.
LDP-sync Indicates whether or not LDP-IGP synchronization is enabled.
Hold Down Time
Interval that the interface does not establish neighbor relationship until
the LDP session converges, in seconds.
Max Cost Time
Interval that IS-IS advertises the maximum cost in LSAs, in seconds.
If infinite is displayed for this field, IS-IS advertises the maximum cost in
LSAs until the LDP session converges.