R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

177
Examples
# Add the frame relay subinterface Serial2/1.1 to mesh-group 3.
<Sysname> system-view
[Sysname] interface serial 2/1
[Sysname-Serial2/1] link-protocol fr
[Sysname-Serial2/1] quit
[Sysname] interface serial 2/1.1
[Sysname-Serial2/1.1] isis mesh-group 3
isis mib-binding
Use isis mib-binding to bind MIBs with an IS-IS process.
Use undo isis mib-binding to restore the default.
Syntax
isis mib-binding process-id
undo isis mib-binding
Default
MIBs are bound with IS-IS process 1.
Views
System view
Default command level
2: System level
Parameters
process-id: Specifies an IS-IS process by its ID in the range of 1 to 65535.
Examples
# Bind MIBs with IS-IS process 100.
<Sysname> system-view
[Sysname] isis mib-binding 100
isis peer-ip-ignore
Use isis peer-ip-ignore to configure the PPP interface not to check the peer's IP address in received hello
packets.
Use undo isis peer-ip-ignore to restore the default.
Syntax
isis peer-ip-ignore
undo isis peer-ip-ignore
Default
The PPP interface checks the peer's IP address upon receiving a hello packet.
Views
Interface view