R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

182
isis timer lsp
NOTE:
This command is not available in loopback interface view.
Use isis timer lsp to configure the minimum interval for sending LSPs on the interface and specify the
maximum LSPs that can be sent per time.
Use undo isis timer lsp to restore the default of 33 milliseconds.
Syntax
isis timer lsp time [ count count ]
undo isis timer lsp
Default
The minimum interval for sending LSPs on the interface is 33 milliseconds.
Views
Interface view
Default command level
2: System level
Parameters
time: Specifies the minimum interval for sending link-state packets, in the range of 1 to 1000
milliseconds.
count: Specifies the maximum number of link-state packets to be sent at one time. The value range is 1
to 1000, and the default is 5.
Examples
# Configure the interval as 500 milliseconds for sending LSPs on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] isis timer lsp 500
Related commands
isis timer retransmit
isis timer retransmit
NOTE:
This command is not available in loopback interface view.
Use isis timer retransmit to configure the interval for retransmitting LSP packets over a point-to-point link.
Use undo isis timer retransmit to restore the default.
Syntax
isis timer retransmit seconds
undo isis timer retransmit