R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

315
[Sysname-pbr-aa-11] apply ip-address next-hop 1.1.1.1 direct
apply ip-df zero
Use apply ip-df zero to set the Don't Fragment (DF) bit in the IP header of matching packets to 0, which
means the packet can be fragmented.
Use undo apply ip-df to remove the configuration.
Syntax
apply ip-df zero
undo apply ip-df
Views
Policy node view
Default command level
2: System level
Examples
# Set the DF bit in the IP header of matching packets to 0.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-pbr-aa-11] apply ip-df zero
apply ip-precedence
Use apply ip-precedence to set a precedence for packets.
Use undo apply ip-precedence to remove the configuration.
Syntax
apply ip-precedence value
undo apply ip-precedence
Views
Policy node view
Default command level
2: System level
Parameters
value: Sets the precedence for IP packets. Eight precedence values (0 to 7) are available. Each
precedence value corresponds to a precedence type, as shown in Table 59. Y
ou can set either a
precedence value or a precedence type for IP packets.
Table 59 IP precedences and the corresponding types
Precedence value
Precedence t
yp
e
0 routine
1 priority
2 immediate