R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

336
Use undo enable ipsec-policy to remove the IPsec policy from the RIPng process.
Syntax
enable ipsec-policy policy-name
undo enable ipsec-policy
Default
No IPsec policy is configured for the RIPng process.
Views
RIPng view
Default command level
2: System level
Parameters
policy-name: IPsec policy name, a string of 1 to 15 characters.
Usage guidelines
The IPsec policy to be applied must have been configured.
Examples
# Apply IPsec policy policy001 to RIPng process 1.
<Sysname> system-view
[Sysname] ripng 1
[Sysname-ripng-1] enable ipsec-policy policy001
filter-policy export (RIPng view)
Use filter-policy export to configure RIPng to filter redistributed routes. Only routes passing the filter can
be advertised in the update messages.
Use undo filter-policy export to disable the redistributed route filtering.
Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } export [ protocol [ process-id ] ]
undo filter-policy export [ protocol [ process-id ] ]
Default
RIPng does not filter any redistributed routing information.
Views
RIPng view
Default command level
2: System level
Parameters
acl6-number: Specifies an ACL by its number in the range of 2000 to 3999 to filter redistributed routes.
ipv6-prefix ipv6-prefix-name: Specifies an IPv6 prefix list by its name, a string of 1 to 19 characters, to
filter redistributed routes.