R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

343
Default command level
2: System level
Parameters
only: Indicates that only the IPv6 default route (::/0) is advertised through the interface.
originate: Indicates that the IPv6 default route (::/0) is advertised without suppressing other routes.
cost: Specifies a metric for the advertised default route, in the range of 1 to 15. The default is 1.
Usage guidelines
After you execute this command, the generated RIPng default route is advertised in a route update over
the specified interface. This IPv6 default route is advertised without considering whether it already exists
in the local IPv6 routing table.
Examples
# Advertise only the default route through Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] ripng default-route only
# Advertise the default route together with other routes through Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] ripng default-route originate
ripng enable
Use ripng enable to enable RIPng on the specified interface.
Use undo ripng enable to disable RIPng on the specified interface.
Syntax
ripng process-id enable
undo ripng [ process-id ] enable
Default
RIPng is disabled on an interface.
Views
Interface view
Default command level
2: System level
Parameters
process-id: Specifies a RIPng process by its ID in the range of 1 to 65535.
Examples
# Enable RIPng 100 on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] ripng 100 enable