R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

375
Field Descri
p
tion
Local address Local IPv6 address.
Remote address Remote IPv6 address.
Transmit Delay Transmit delay of sending LSAs.
State Interface state.
Timer intervals configured, Hello: 10, Dead: 40,
Wait: 40, Retransmit: 5
Timer intervals in seconds:
• Hello—10.
• Dead—40.
• Wait—40.
• Retransmit—5.
Hello due in 00:00:02 Send hello packets in 2 seconds.
Adjacency state Adjacency state.
IPsec policy name IPsec policy used on the virtual link.
SPI SPI defined in the IPsec policy.
enable ipsec-policy (OSPFv3 area view)
Use enable ipsec-policy to apply an IPsec policy in the OSPFv3 area.
Use undo enable ipsec-policy to remove the IPsec policy from the OSPFv3 area.
Syntax
enable ipsec-policy policy-name
undo enable ipsec-policy
Default
No IPsec policy is applied in an area.
Views
OSPFv3 area view
Default command level
2: System level
Parameters
policy-name: Specifies an IPsec policy by its name, a string of 1 to 15 characters.
Usage guidelines
The IPsec policy to be applied must have been configured.
Examples
# Apply IPsec policy policy001 to OSPFv3 area 0.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 0
[Sysname-ospfv3-1-area-0.0.0.0] enable ipsec-policy policy001