R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

456
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test ebgp-max-hop
peer enable (IPv6 address family view)
Use peer enable to enable an IPv4 peer or peer group.
Use undo peer enable to disable an IPv4 peer or peer group.
Syntax
peer { ipv4-group-name | ipv4-address | ipv6-address } enable
undo peer { ipv4-group-name | ipv4-address | ipv6-address } enable
Default
No IPv4 peer or peer group is enabled.
Views
IPv6 address family view
Default command level
2: System level
Parameters
ipv4-group-name: Specifies the name of an IPv4 peer group, a string of 1 to 47 characters. The IPv4 peer
group should be created beforehand.
ipv4-address: Specifies the IPv4 address of a peer.
ipv6-address: Specifies the IPv6 address of a peer.
Usage guidelines
If an IPv4 peer or peer group is disabled, the router does not exchange routing information with it.
Examples
# E n a b l e p e e r 1.1.1.1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1.1.1.1 enable
# Enable peer 1::1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1::1 group group1
[Sysname-bgp-af-ipv6] peer 1::1 enable
peer fake-as (IPv6 address family view)
Use peer fake-as to configure a fake local AS number for a peer or peer group.
Use undo peer fake-as to remove the configuration.