R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

462
Default
The feature is disabled.
Views
IPv6 address family view
Default command level
2: System level
Parameters
ipv4-group-name: Specifies the name of an IPv4 peer group, a string of 1 to 47 characters. An IPv4 peer
group must be created successfully in BGP view before being activated here.
ipv4-address: Specifies the IPv4 address of a peer.
Examples
# Enable exchange of labeled IPv6 routes with peer 2.2.2.2.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 2.2.2.2 label-route-capability
peer log-change (IPv6 address family view)
Use peer log-change to enable the logging of session state and event information for a specific peer or
peer group.
Use undo peer log-change to remove the configuration.
Syntax
peer { ipv6-group-name | ipv6-address } log-change
undo peer { ipv6-group-name | ipv6-address } log-change
Default
The logging is enabled.
Views
IPv6 address family view
Default command level
2: System level
Parameters
ipv6-group-name: Specifies the name of a peer group, a string of 1 to 47 characters.
ipv6-address: Specifies the IPv6 address of a peer.
Examples
# Enable the logging of session state and event information for peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family