R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

467
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 public-as-only
peer reflect-client (IPv6 address family view)
Use peer reflect-client to configure the router as a route reflector and to specify a peer or peer group as
a client.
Use undo peer reflect-client to remove the configuration.
Syntax
peer { group-name | ipv4-address | ipv6-address } reflect-client
undo peer { group-name | ipv4-address | ipv6-address } reflect-client
Default
Neither route reflector nor client is configured.
Views
IPv6 address family view
Default command level
2: System level
Parameters
group-name: Specifies the name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: Specifies the IPv4 address of a peer.
ipv6-address: Specifies the IPv6 address of a peer.
Examples
# Configure the local device as a route reflector and specify the peer group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test
[Sysname-bgp-af-ipv6] peer test reflect-client
Related commands
• reflect between-clients
• reflector cluster-id
peer route-limit (IPv6 address family view)
Use peer route-limit to set the maximum number of prefixes that can be received from a peer or peer
group.
Use undo peer route-limit to restore the default.
Syntax
peer { group-name | ipv4-address | ipv6-address } route-limit prefix-number [ { alert-only | reconnect
reconnect-time } | percentage ] *