R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

59
rip triggered
Use rip triggered to enable triggered RIP.
Use undo rip triggered to disable triggered RIP.
Syntax
rip triggered
undo rip triggered
Default
The triggered RIP is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
Triggered RIP can only run on link layer protocols PPP, Frame Relay, and X.25.
Examples
# Enable triggered RIP.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] rip triggered
rip version
Use rip version to specify a RIP version for the interface.
Use undo rip version to remove the specified RIP version.
Syntax
rip version { 1 | 2 [ broadcast | multicast ] }
undo rip version
Default
No RIP version is configured for an interface, which uses the global RIP version. If the global RIP version
is not configured, the interface can only send RIPv1 broadcasts and can receive RIPv1 broadcasts and
unicasts, and RIPv2 broadcasts, multicasts, and unicasts.
Views
Interface view
Default command level
2: System level
Parameters
1: Specifies RIP version 1.
2: Specifies RIP version 2.